Removing The Management Module - 3Com 3C16685 User Manual

Figure 2 Inserting the Management Module (either slot can be used)
5 Fix the front panel of the management module to the hub using the
two screws from the blanking plate, as shown in
Figure 3 Fixing the Management Module in Place

Removing the Management Module

To remove the management module from the Dual Speed Hub 500:
1 Ensure that the hub is disconnected from the power supply, and that
you are wearing an anti-static wristband connected to a suitable
earth point.
2 Place the hub on a flat surface. Using a suitable screwdriver, remove
the screws that hold the management module in place. Do not
remove any other screws from the rear of the hub.
3 Remove the management module and place it in the packaging that
it was supplied in (or other appropriate anti-static packaging).
Installing and Removing the Management Module 21
Figure 3.