Table of Contents
Advertisement
68
C
3: U
HAPTER
If you have a Dual Speed Hub 500 with a serial number less than
0600/00000000000, upgrading the software to version 2.1x or
above will not give you support for the RMON Filter and Capture
groups on the 100Mbps segments, which means that you cannot
perform RMON Filter Capture for the 100Mbps segments.
To configure RMON Filter capture:
1 At the top-level menu, enter:
system capture
2 Enable or disable RMON Filter capture as required.
Using PING to Test the Connections to Other Devices
From the command line interface you can send out a PING request to
test that a device on your network can receive and transmit
information to the stack. You can use PING to ensure that the stack is
installed correctly, and that your network connections are good.
To PING a device:
1 At the top-level menu, enter:
ip ping
2 You are prompted for the device's IP address:
Enter destination IP address:
Enter the IP address of the device.
The command line interface transmits a single PING request to the
device. It then displays a message telling you if it received a response,
for example:
Starting ping, resolution of displayed time is
10 milli-sec
Response from 192.168.100.30: 1 router hop. time = 10ms
Resetting the IP Configuration
You can reset the IP configuration for the whole stack back to factory
defaults.
To do this:
1 At the top-level menu, enter:
ip initializeConfig
The following warning is displayed:
C
SING THE
OMMAND
L
I
INE
NTERFACE
Advertisement
Table of Contents
