Management Settings Pages; Documentation - 3Com 3C16685 User Manual

Current State Of Switch Displays the mode of operation for the
unit's internal switch. The switch can be:
Operational — The switch is active and passing traffic between
the 10Mbps and 100Mbps segments in the unit.
Standby — The switch is inactive but will become active if
required by the stack (and if the unit is the bottom unit in the
stack). This may happen if the currently active switch is disabled
or disconnected from one or both of the stack's cascaded
segments.
Off — The switch is disabled.
CAUTION: The Hub's management facilities are accessed internally
via the 10Mbps segment. If you try to disable the segment switch on
the bottom unit of the stack over a 100Mbps connection (via the
command line interface or the web management interface), you will
lose the management connection. If this should occur, follow the
procedure given on
If you have a Dual Speed Hub 500 with a serial number less than
0600/00000000000, upgrading the software to version 2.1x or
above will not give you support for segment configuration.

Management Settings Pages

This section describes the fields that appear on the pages in the
Management Settings category. The first page displayed is the
Documentation page.

Documentation

This page specifies the directories or URLs that are used to access the
online help system and documentation, as shown in
To access to online help system and documentation, the files must be
set up; refer to
page
this page, use forward-slashes (/) instead of back-slashes (\). For
example, c:\myfile becomes c:/myfile.
page
"Online Help System and Documentation"
82. When specifying the locations of the files in the fields on
Management Settings Pages
65, "Management Recovery
91
Procedure".
Figure 18.
on