Table of Contents
Advertisement
52
C
3: U
HAPTER
Enter a SLIP address or press Return if it is not required.
6 Finally, you are prompted for a SLIP subnet mask:
Enter SLIP subnet mask [255.255.255.0]:
Enter a SLIP subnet mask or press Return if it is not required.
Any changes that you make will take effect after a few seconds. You
do not need to reset the stack.
Enabling and Disabling BOOTP
To enter new IP settings:
1 At the top-level menu, enter:
ip interface bootp
2 You are prompted for the unit's new BOOTP state:
Enter new value (enabled, disabled) [enabled]:
Enable or disable BOOTP as required.
Viewing the Configuration
You can use the display command to show current configuration
information for your unit or stack.
Displaying the IP Information
At the top-level menu, enter:
ip interface display
The command line interface displays the IP address, subnet mask,
default router address, SLIP address and SLIP subnet mask for the
unit.
Displaying the Administration Information
At the top-level menu, enter:
system display
The command line interface displays information similar to this
example:
3Com Dual Speed Hub 500 (3C16611)
Unit Name: Marketing
Location: Top floor
Contact: James
C
SING THE
OMMAND
L
I
INE
NTERFACE
Advertisement
Table of Contents
