User Interface Configuration; Entering User Interface View; Define The Login Header - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
VTY is numbered after AUX user interface. The absolute number of the first VTY is
incremented by 1 than the AUX user interface number.
II. Relative number
The relative number is in the format of "user interface type" + "number". The "number"
refers to the internal number for each user interface type. This method can only specify
one interface or one group of interfaces for a user interface type instead of different
user interface types.
It follows the rules below:
Number of Console user interface: console 0.
Number of AUX user interface: AUX 0.
Number of VTY: The first VTY interface is designated as VTY 0; the second one is
designated as VTY 1, and so on.

4.2 User Interface Configuration

The following sections describe the user interface configuration tasks.

Entering User Interface View

Define the Login Header

Configuring Asynchronous Port Attributes
Configuring Terminal Attributes
Managing Users
Configuring Modem Attributes
Configuring Redirection
4.2.1 Entering User Interface View
The following command is used for entering a user interface view. You can enter a
single user interface view or multi user interface view to configure one or more user
interfaces respectively.
Perform the following configuration in system view.
Table 4-1 Enter user interface view
Enter a single user interface view or
multi user interface views
4.2.2 Define the Login Header
The following command is used for configuring the displayed header when user login.
Operation
4-2
Chapter 4 User Interface Configuration
Command
user-interface [ type ] first-number
[ last-number ]