3Com 8800 Configuration Manual page 683

3Com Switch 8800 Configuration Guide
Table 46-15 Send the configuration information to the console terminal.
Device
Switch
3) Sending the configuration information to the monitor terminal
Table 46-16 Send the configuration information to the monitor terminal
Device
Switch
4) Sending the configuration information to the log buffer.
Configuration
Enable info-center
Set the information
output direction to the
Console
Set information source
Enable terminal
display function
Configuration
Enable info-center
Set the information
output direction to the
monitor
Set information source
Enable the terminal
display function and
this function for the
corresponding
information
46-12
Chapter 46 System Maintenance and Debugging
Default
Configuration description
value
By default,
Other configurations are valid
info-center
only if the info-center is enabled.
is enabled.
— —
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
—
turn on
corresponding
defining
information.
You can
— information
terminal display function
Default
Configuration description
value
By default,
Other configurations are valid
info-center
only if the info-center is enabled.
is enabled.
— —
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
—
turn on
corresponding
defining
information.
For Telnet terminal and dumb
terminal, to view the information,
— you must enable the current
terminal display function using
the terminal monitor command.
the switch of the
module before
output debugging
view debugging
after enabling
the switch of the
module before
output debugging