3Com 8800 Configuration Manual page 34

3com 8800: install guide

Hide thumbs Also See for 8800:

Table of Contents

3Com Switch 8800 Configuration Guide

Chapter 2 Logging into Switch

By default, the password is required for authenticating the Modem user to log in the

switch. If a user logs in via the Modem without password, he will see the prompt "Login

password has not been set !.".

<SW8800> system-view

System View: return to User View with Ctrl+Z..

[SW8800] user-interface aux 0

[SW8800-ui-aux0] set authentication password simple xxxx (xxxx is the preset login

password of the Modem user.)

Step 2: As shown in the figure below, to set up the remote configuration environment,

connect the Modems to a PC (or a terminal) serial port and the switch AUX port

respectively.

Modem serial port line

Telephone line

Figure 2-8 Set up remote configuration environment

Step 3: Dial for connection to the switch, using the terminal emulator and Modem on the

remote end. The number dialed shall be the telephone number of the Modem

connected to the switch. See the two figures below.

Troubleshooting