3Com 8800 Configuration Manual page 406

3Com Switch 8800 Configuration Guide
Configure traffic statistics which only
applies link group ACL
Remove traffic statistics setting which
only applies link group ACL
Display traffic statistics for the port
Note:
The system counts the traffic on all ports in the group after you use the traffic-statistic
command in port group view.
system-index index here is the system index for an ACL rule. When delivering a rule,
the system assigns an index to it, for convenience of later retrieval. You can also assign
a system index for it when delivering an ACL rule with this command. However, you are
not recommended to assign a system index if not urgently necessary.
See the corresponding Command Manual for details of the commands.
33.3.11 Displaying and Debugging QoS Configuration
After these configurations are completed, you can use the display command in any
view to view QoS running and check configuration result. You can clear QoS statistics
using the reset traffic-statistic command in Ethernet port view or port group view.
Table 33-16 Display and debug QoS configurations
Display
configuration of a port
Display
configuration of a port
Display
configuration of a port
Display traffic statistics of a
port
Display
configuration
Display QoS configurations of
all ports
Operation
traffic mirroring
traffic priority
traffic redirection
port mirroring
traffic-statistic inbound link-group
{ acl-number | acl-name } [ rule rule
[ system-index index ] ] [ tc-index
index ]
undo traffic-statistic
link-group { acl-number | acl-name }
[ rule rule ]
display qos-interface [ interface-name
| interface-type
traffic-statistic
Command
display qos-interface
interface-type interface-num ] mirrored-to
display qos-interface
interface-type interface-num ] traffic-priority
display qos-interface
interface-type interface-num ] traffic-redirect
display qos-interface
interface-type interface-num ] traffic-statistic
display mirroring-group [ groupid ]
display qos-interface
interface-type interface-num ] all
33-22
Chapter 33 QoS Configuration
inbound
interface-num
[ interface-name
[ interface-name
[ interface-name
[ interface-name
[ interface-name
]
|
|
|
|
|