Configuring Route Filtering - 3Com 8800 Configuration Manual

3Com Switch 8800 Configuration Guide
Perform the following configuration in RIP view.
Table 18-6 Configure RIP to import routes of other protocols
Configure RIP to import routes of other
protocols
Cancel the imported routing information
of other protocols
Set the default routing metric
Restore the default routing metric
By default, RIP does not import the route information of other protocols.
If you do not specify the routing metric when importing a route, the default routing
metric 1 is used.

18.2.7 Configuring Route Filtering

The router provides the route filtering function. You can configure the filter policy rules
through specifying the ACL and ip-prefix for route import and advertisement. Besides,
to import a route, the RIP packet of a specific router can also be received by
designating a neighbor router.
Perform the following configuration in RIP view.
I. Configuring RIP to filter the received routes
Table 18-7 Configure RIP to filter the received routes
Configure RIP to filter the received routing
information advertised by the specified address
Cancel filtering the received routing information
advertised by the specified address
Configure RIP to filter the received global
routing information
Cancel filtering the received global routing
information
Operation
Operation
18-6
Chapter 18 RIP Configuration
Command
import-route protocol [ cost value |
route-policy route-policy-name ]*
undo import-route protocol
default cost value
undo default cost
Command
filter-policy
ip-prefix-name import
undo filter-policy
ip-prefix-name import
filter-policy {
ip-prefix ip-prefix-name } import
undo filter-policy { acl-number |
ip-prefix ip-prefix-name } import
gateway
gateway
acl-number |