3Com 8800 Configuration Manual page 438

3Com Switch 8800 Configuration Guide
Table 36-16 Display the static LSP information
Display the static LSP information
II. Displaying MPLS-enabled interfaces
After accomplishing the configuration tasks mentioned previously, you can execute the
display command in any view to view the information related to the MPLS-enabled
interfaces and thus to evaluate the effect of the configurations.
Table 36-17 Display information of the MPLS-enabled interfaces
Display
MPLS-enabled interfaces
III. Displaying LSP
Execute the following commands in any view to display the information related to MPLS
LSP.
Table 36-18 Display the information about MPLS LSP
Display the information about MPLS
LSP
IV. Debugging MPLS
You may execute the debugging command in user view to debug the information
concerning all interfaces with MPLS function enabled.
As enabling debugging may affect the router performance, you are recommended to
use this command when necessary. Execute the undo form of this command to disable
the corresponding debugging.
Table 36-19 Enable/disable debugging for MPLS
Operation
Enable debugging for
MPLS LSP
Disable debugging for
MPLS LSP
Operation
Operation
information of
Operation
debugging mpls lspm { agent | all | event | ftn |
interface | packet | policy process | vpn }
undo debugging mpls lspm { agent | all | event | ftn |
interface | packet | policy process | vpn }
36-9
Chapter 36 MPLS Basic Capability Configuration
Command
display mpls static-lsp [ include text |
verbose ]
Command
the
display mpls interface
Command
display mpls lsp [ include text |
verbose ]
Command