3Com 8800 Configuration Manual page 411

3Com Switch 8800 Configuration Guide
Re-allocate service parameters for the packets from PC1.
[SW8800-GigabitEthernet7/1/1]
remark-policed-service dscp 63
33.4.4 Traffic Redirection Configuration Example
I. Network requirements
Forward the packets sent from PC1 (IP 1.0.0.1) during the time range from 8:00 to
18:00 every day to the address 2.0.0.1.
II. Network diagram
VLAN2, VLAN2,
1.0.0.1/8 1.0.0.1/8
PC1 PC1
Figure 33-9 Network diagram for traffic redirection configuration
III. Configuration procedure
1) Define the time range.
Define the time range from 8:00 to 18:00.
[SW8800] time-range 3Com 8:00 to 18:00 daily
2) Define the traffic from PC1.
Create a number-based basic ACL 2000 and enter it.
[SW8800] acl number 2000
Define ACL rule for the traffic from PC1.
[SW8800-acl-basic-2000] rule 0 permit source 1.0.0.1 0 time-range 3Com
3) Modify the next hop for the packets from PC1.
Define the next hop for the packets from PC1 as 2.0.0.1.
[SW8800-GigabitEthernet7/1/1] traffic-redirect inbound ip-group 2000 rule 0
next-hop 2.0.0.1
GE7/1/8 GE7/1/8
GE7/1/2 GE7/1/2
GE7/1/1 GE7/1/1
traffic-priority
VLAN3, VLAN3,
2.0.0.1/8 2.0.0.1/8
PC2 PC2
33-27
Chapter 33 QoS Configuration
inbound ip-group 2000