Disable Icmp; Disable Interface <Interface_Name>; Disable Ip Forwarding; Disable Ip Network <Network_Name> - 3Com OfficeConnect 3CP4144 Cli User's Manual

disable command
password

disable icmp

disable interface
<interface_name>

disable ip forwarding

disable ip network
<network_name>

disable ip rip

disable ip routing

disable ip
static_remote_routes
disable ipx network
<network_name>

disable lan access

disable link_traps
interface
<interface_name>
disable network service
<service_name>
disable security_option
snmp user_access
Disables the console password feature.
Disables the Internet Control Message Protocol .
Disables the specified interface. A disabled interface remains in the interface
table, but will not transmit or receive any data. Use list interfaces to see the
currently defined interfaces, and their status.
Causes the system to stop forwarding any packets over IP networks.
Disables the specified IP network. Make sure there is no activity on this network
before disabling it.
Disables the RIP routing algorithm on all IP networks. You can use show ip routing
to see the current status of IP routing. This saves system space by preventing a
large RIP database, which is useful for networks connecting over the WAN
interface.
Disables all routing protocols on all IP networks. Currently, the only routing
protocol is RIP, which means that disable ip rip performs the same function. Use
show ip routing to see the current status of IP routing.
Disables all statically defined remote routes on all IP networks, that you previously
defined using add ip route. You can list the current IP routes using list ip routes.
Disables the specified IPX network. Use list ipx networks to see which IPX
networks are defined, and their current status.
When the access list is enabled, this command disables access to Hosts on the
local LAN interface. When disabled, all frames received on the LAN interface are
subject to the access list check. If the corresponding LAN subnet is not in the
access list, the frame is silently discarded.
Prevents SNMP from sending linkup and linkdown traps for the specified interface.
You can see if the interface is currently enabled for traps by using the show
interface settings command.
Disables a network service, such as TELNET or TFTP. If close_active_connection' was
specified as TRUE in the add network_service command, then all active
connections will be closed when the server is disabled.
Turns off SNMP access to the CLI. This prevents remote users from using SNMP
and possibly damage the configuration. You can use enable security_option snmp
user_access to re-enable full SNMP access. NOTE: This function is not supported in
the current release.
CLI Commands B-13