Kill; Kill <"Process Name; List; List Active Interfaces - 3Com OfficeConnect 3CP4144 Cli User's Manual

KILL

kill <"process name">

LIST

list access

list active interfaces

list bridge forwarding

list call events

list call log

Kills an active process. Use list processes to see which processes are currently
active. You can only kill a process that you started. An example would be a ping
that you started that you now wish to kill.
Displays all IP Subnet addresses in the access list.
Displays the index, name, operational status, and administration status of all active
interfaces. The output is the same as the list interfaces command, except
non-active interfaces are not displayed. Inactive interfaces are interfaces with no
current connections.
Displays the forwarding and filtering information
MAC address - A unicast MAC address for which the bridge has forwarding
and/or filtering data
Status - One of:
other - not one of the following
invalid - aged out
learned - learned, and in use
self - statically defined, and in use
mgmt - unknown, but filtering information exists
RxPkt - Number of packets received from this MAC station
RxOctets - No. of bytes (octets) received from this MAC station
Fltr - Number of packets received from this MAC station that were filtered
out (discarded)
Fwd - Number of packets received from this MAC station that were
forwarded
TxPkt - Number of packets forwarded to this MAC station
TxOctets - Number of bytes forwarded to this MAC station
Displays the last twenty call events. This is useful when trying to determine why a
call over the WAN is not being established. The table displays the system, the up
time, and the event.
Displays the current call status for all VCs for which a call has been attemped.
Each entry will include the VC name, the current call state (Disconnected,
Connecting, or Connected), and the reason why the last call was cleared. Reasons
for clearing include: line down, PPP timeout, Authentication error, Network
configuration error, and termination initiated from either the local or remote side.
CLI Commands B-17