List Ip Interface_Block; List Ip Networks; List Ip Routes; List Ipx Networks - 3Com OfficeConnect 3CP4144 Cli User's Manual

list ip interface_block

list ip networks

list ip routes

list ipx networks

list ipx routes

Type - interface type: Ethernet or Token Ring
If Name - eth:1, DA:1 or loopback
Displays the IP addresses associated with each system interface. If the interface has
a point-to-point connection, then the neighbor field contains the address of the
remote system. This command lists:
Address - IP address of the interface
Neighbor - IP address of the remote system
Status - status of the connection; ENABLED or DISABLED
Interface - eth:1, DA:1 or loopback
Displays all the IP networks you previously defined using the add ip network
command. It also lists:
Name - network designation
Prot - always the IP protocol
Int - name of the interface this network runs on
State - state of the network; ENABLED or DISABLED
Type - STATIC or DYNAMIC network
Network Address - address of the IP network
Displays all the statically defined IP routes that you previously defined using the
add ip route command. It lists:
Destination - IP address that the route resolves to
Prot - LOCAL or RIP
NextHop - address of the gateway used to reach this route
Metric - number of router hops away this route is from the system
If - interface that the route uses
Displays the IPX networks that you previously defined using the add ipx network
command. It lists:
Name - designation you assigned this network
Prot - protocol; always IPX
Int - interface each IPX network runs on
State - ENABLED or DISABLED
Type - STATIC or DYNAMIC
Network Address - network address of this IPX network
Displays the IPX routes that you previously defined using the add ipx route
command, plus the defined IPX nodes. It lists:
Network Addr - network address of this route
Prot - protocol used to find this route: LOCAL, RIP, STATIC, NLSP, OTHER
CLI Commands B-19