Show Call_Log; Show Command; Show Configuration; Show Critical_Event Settings - 3Com OfficeConnect 3CP4144 Cli User's Manual
3com officeconnect 3cp4144: users guide
Hide thumbs
Also See for OfficeConnect 3CP4144:
- Get started manual (58 pages) ,
- How to set up (4 pages) ,
- Release note (2 pages)
Table of Contents
Advertisement
B-38
A
B: CLI COMMAND DESCRIPTION
PPENDIX
show call_log
show command
show configuration
show critical_event
settings
Spanning Tree Forward Delay - delay after coming up before learning,
default is 15
Spanning Tree Priority - this bridge's bid to be root bridge, default is
32768
Access MACs Only - This can be enabled or disabled.
Spanning Tree Mode - sets spanning tree algorithm on. Default is
DISABLED
Base MAC Address - address of the bridge
Number of Networks - number of networks in this bridge
Type - type of bridge: TRANSPARENT_ONLY is the default
Displays the current call status of a specified VC.
Fields:
Call State: current call state of the call (i.e. Disconnected, Connecting,
Connected).
Last Clearing reason: indicates why the call was cleared. Reasons for clearing
include, line down, PPP timeout, Authentication error, Network configuration
error, and termination initiated from the local and remote side.
IP, IPX, and Bridge status: current status of each network layer.
Configured - protocol is configured for this VC and the call is being
initiated
Not configured - The protocol is disabled on this VC.
Established - Protocol was negoitated successfully and is currently active
on this VC.
Failure - Protocol was configured, but there was a failure in the PPP
negotiation while attempting to initiate the network layer.
Displays the settings for Command History Depth, and the Current Prompt. You
can modify the history depth using set command history, and alter the prompt
using set command prompt. Prompts can hold a maximum of 64 characters. For
example:
History Depth:
10
Current Prompt: OCR-DSL>
Local Prompt:
OCR-DSL>
Displays a variety of system information including: System Identification,
Authentication Remote, Remote Accounting, Interfaces, IP forwarding, IPX Default
Gateway, Bridge Spanning Tree, and DNS Domain.
Displays where the log files for critical event messages are stored in the FLASH file
system.
Advertisement
Table of Contents
