Service And Repairs; Pto Solenoid Valve Coil - Toro Groundsmaster 7200 Service Manual

Service and Repairs

NOTE: For engine electrical component repair informa-
tion, see the Kubota Workshop Manual, Diesel Engine,
05 Series.

PTO Solenoid Valve Coil

The PTO solenoid valve coil on the transmission (Fig.
44) can be replaced without opening the hydraulic sys-
tem.
Removal
1. Park machine on a level surface, lower cutting deck
(or implement), engage parking brake, stop engine and
remove key from the ignition switch.
2. Disconnect the wire harness electrical connector
from the PTO solenoid valve coil connector.
3. Remove the nut from the spool assembly.
4. Slide the coil assembly from the solenoid valve stem
(Fig. 45).
5. Clean any corrosion or dirt from the valve stem.
Installation
1. Slide new coil assembly, seals and washers onto the
solenoid valve stem. Make sure to properly position
seals and washers (Fig. 45).
IMPORTANT: When securing solenoid valve coil to
solenoid, do not over- tighten hex nut.
2. Install the hex nut onto the spool assembly and
torque nut from 53 to 69 in- lb (5.9 to 7.8 N- m).
3. Connect the wire harness electrical connector to the
solenoid valve coil connector.
Groundsmaster 7200/7210
2
1. Transmission
2. Solenoid valve and coil
2
53 to 69 in- lb
(5.9 to 7.8 N- m)
1. Hex nut
2. Lock washer
3. Washer
Page 5 - 31
1
3
Figure 44
3. Coil connector
4
3
4
5
1
Figure 45
4. Seal
5. Solenoid valve coil
Electrical System