Gearbox - Toro Groundsmaster 7200 Service Manual

Gearbox

14
5
RIGHT
FRONT
1. Flange nut (3 used)
2. Washer (3 used)
3. LH gearbox bracket
4. Mount (3 used)
5. Carriage screw (3 used)
6. Gearbox
Removal (Fig. 15)
1. Park machine on a level surface, lower cutting deck
(or implement), stop engine, engage parking brake and
remove key from the ignition switch.
2. Lift the footrest, exposing the top of the cutting deck.
Support the footrest with prop rod.
3. Remove belt covers from top of cutting deck.
4. Remove drive belt from deck pulleys.
Cutting Deck
1
2
9
4
12
7
Figure 15
7. Grommet (5 used)
8. Taperlock bushing
9. RH gearbox bracket
10. Cap screw (4 used)
11. Lock washer (4 used)
12. Woodruff key
Do not start the engine and engage the PTO
switch when the PTO drive shaft is discon-
nected from the cutting deck (or implement). If
the engine is started and the PTO shaft is al-
lowed to rotate, serious personal injury and
machine damage could result. If the PTO drive
shaft is disconnected from the cutting deck (or
implement), remove fuse F1 (15 amp) from fuse
block to prevent unintentional engagement of
the PTO clutch.
Page 7 – 14
6
3
11
10
13
8
17
15
13. Deck drive pulley
14. RH deck cover
15. LH deck cover
16. Knob (2 used)
17. Set screw (2 used)
18. Retainer nut (2 used)
WARNING
Groundsmaster 7200/7210
16
7
18