Toro Groundsmaster 7200 Service Manual page 205

Removal (Fig. 31)
1. Park machine on a level surface, lower cutting deck
(or implement), stop engine, engage parking brake and
remove key from the ignition switch.
2. Unlatch and raise hood.
3. Remove hair pin cotter (item 6) from left side frame
rod.
4. Slide hood to left side of machine to free hood sup-
port from frame rods.
5. Remove hood from machine.
6. If necessary, remove hood components using Figure
31 as a guide.
Groundsmaster 7200/7210
Installation (Fig. 31)
1. Install all removed hood components using Figure
31 as a guide. If intake screen was removed from hood,
make sure that hood support, seal angle and prop rod
support are attached to hood before installing screen.
Secure screen to hood with screws and lock nuts.
Torque fasteners that secure screen from 35 to 45 in–lb
(4.0 to 5.1 N–m).
2. Check condition of all seals on frame and hood. Re-
place damaged or missing seals. Check that no gaps ex-
ist between hood components and machine frame. If
necessary, seal gaps with silicone caulk.
3. Position hood to machine and slide hood support
onto frame rods.
4. Secure hood to frame rods with hair pin cotter (item
6).
5. Close and latch hood.
Page 6 – 29 Chassis