Toro Groundsmaster 7200 Service Manual page 102

42.If necessary, remove two (2) bearings from PTO
gear. Discard removed bearings. Remove retaining ring
from groove in PTO gear bore.
43.Remove two (2) plugs from transmission pump
housing. Remove and discard O–rings from plugs.
44.Remove three (3) socket head screws that secure
both side covers to transmission pump housing.
45.Carefully slide side covers from trunnion shafts and
housing. Remove and discard O–rings from side cov-
ers.
46.Remove retaining rings that secure oil seals into both
side covers. Remove oil seals from side covers. Discard
seals.
Hydraulic System
1
2
1. Bearing
2. PTO gear
2
1. Socket head plug
2. Hex plug
4
5
1. Side cover
2. O–ring
3. Pump housing
Page 4 – 66
3
1
Figure 63
3. Retaining ring
3
1
Figure 64
3. Pump housing
2
3
Figure 65
4. Retaining ring
5. Oil seal
Groundsmaster 7200/7210
1