Removal (Fig. 1)
1. Park machine on a level surface, lower cutting deck
(or implement), stop engine and remove key from the
ignition switch.
NOTE: If machine is equipped with Polar Trac
see Polar Trac
Wheels in this section for information
TM
regarding wheel removal.
2. Loosen (but do not remove) lug nuts that secure rear
wheel that is to be removed.
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 – Safety. Do not
support machine on rear wheel hubs (brake ro-
tors).
3. Jack up rear wheel and use appropriate jack stands
to support the machine.
4. Remove lug nuts from drive studs. Remove rear
wheel from machine.
Groundsmaster 7200/7210
Installation (Fig. 1)
1. Secure wheel to machine with five (5) lug nuts.
2. Lower wheel to ground. Torque wheel lug nuts in a
crossing pattern from 75 to 85 ft–lb (102 to 115 N–m).
Kit,
TM
Page 6 – 5
Chassis