Toro Groundsmaster 7200 Service Manual page 83

8. Put clean plugs in disconnected hydraulic hoses and
fittings to prevent system contamination.
9. Remove two (2) washer head screws and tank sup-
port that retain hydraulic tank to frame.
10.Remove hydraulic tank toward front of machine.
11. Inspect foam strips under hydraulic tank. Replace
strips if damaged.
12.As needed, remove fittings from hydraulic tank using
Figure 29 as a guide. Discard and replace any removed
O–rings.
Hydraulic Tank Inspection (Fig. 29)
1. Clean hydraulic tank and suction strainer with sol-
vent.
2. Inspect hydraulic tank for leaks, cracks or other dam-
age.
Hydraulic Tank Installation (Fig. 29)
1. If suction strainer was removed from hydraulic tank,
place new, lubricated O–ring on strainer. Thread strain-
er into tank and torque from 60 to 66 ft–lb (82 to 90
N–m).
2. Attach removed fittings with new, lubricated O–rings
to hydraulic tank using Figure 29 as a guide (see Hy-
draulic Fitting Installation in the General Information
section of this chapter). Tighten fittings to torque values
identified in Figure 29.
3. Position hydraulic tank to machine. Secure tank to
frame with tank support and two (2) washer head
screws.
4. Remove plugs that were installed to hydraulic hoses
and fittings during the removal procedure.
5. Attach hydraulic hoses to fittings on hydraulic tank
using labels placed during removal (see Hydraulic Hose
and Tube Installation in the General Information section
of this chapter).
6. Install brake handle to machine (see Parking Brake
Assembly in the Service and Repairs section of Chapter
6 – Chassis). Make sure that parking brake switch op-
eration is correct after brake handle is installed.
7. Secure front cover to machine (Fig. 30).
Groundsmaster 7200/7210
8. Fill hydraulic tank with new hydraulic fluid.
9. Install operator seat and seat base (see Operator
Seat Installation in the Service and Repair section of
Chapter 6 – Chassis).
10.Operate machine. Check hydraulic oil level and ad-
just if necessary. Check hydraulic components for leaks.
Tighten any loose connections.
RIGHT
FRONT
3
1
2
1. Screw (3 used)
2. Front cover
3
FRONT
1. Hydraulic tank
2. Transmission
Page 4 – 47
4
Figure 30
3. Frame
4. Foam strip (3 used)
2
1
Figure 31
3. Gear pump
Hydraulic System