Toro Groundsmaster 7200 Service Manual page 101

39.Disassemble PTO shaft assembly:
A. Using a bearing puller, remove bearing from PTO
shaft. Discard bearing.
B. Remove spacer from PTO shaft.
C. Slide gear and clutch assembly from PTO shaft.
D. Remove key from PTO shaft slot.
E. Remove two (2) seal rings from PTO shaft
grooves. Discard seal rings.
F. Remove B–plate, C–plate, three (3) A–plates and
three (3) friction plates from PTO shaft.
G. Using a bearing puller, remove bearing from PTO
shaft. Discard bearing.
40.Slide three (3) rods from holes in clutch assembly.
41.Slide PTO gear assembly from clutch assembly.
NOTE: Because individual clutch components are not
available, disassembly of the clutch assembly is not
necessary.
Groundsmaster 7200/7210
2
1. Bearing
2. PTO shaft
3. Spacer
7
2
1. Seal ring (2 used)
2. PTO shaft
3. B–plate
4. C–plate
2
1. Rod (3 used)
2. Clutch assembly
Page 4 – 65
5
6
4
Figure 60
4. Gear
5. Clutch assembly
6. Key
5 5 5
1
6
6
Figure 61
5. A–plate (3 used)
6. Friction plate (3 used)
7. Bearing
3
1
Figure 62
3. PTO gear
Hydraulic System
1
3
4
6
3