12.Secure wire harness to engine with cable ties at loca-
tions noted during engine removal.
13.Carefully position fan shroud around the engine fan.
14.Install radiator to machine (see Radiator Installation
in this section). Make sure that radiator hoses are se-
cured with hose clamps.
15.Make sure that drain plug is installed in radiator. Fill
radiator with coolant.
16.Install muffler to the engine (see Exhaust System
Installation in this section).
17.Connect throttle cable to the support bracket and
swivel on the speed control lever.
18.Adjust throttle cable (see Adjust Throttle Cable in the
Adjustments section of this chapter).
Groundsmaster 7200/7210
19.Connect and secure positive battery cable to the bat-
tery. Then connect negative battery cable.
20.Install air cleaner to the engine (see Air Cleaner As-
sembly Installation in this section).
21.Check engine oil level and adjust as needed.
22.Secure rear panel to frame with six (6) flange head
screws (Fig. 10).
23.Install hood to the machine (see Hood Installation in
the Service and Repairs section of Chapter 6 – Chas-
sis).
24.Bleed fuel system.
25.Close and latch hood. Lower operator seat.
Page 3 – 17
Kubota Diesel Engine