Toro Groundsmaster 7200 Service Manual page 113

50.Lubricate solenoid valve spring, sleeve and spool
with clean hydraulic oil and install into pump body. Make
sure that sleeve is installed so that holes are closest to
the spring location and that step in spool is toward spring
location as well. Place pin in spool.
51.Install solenoid valve stem into pump body and
torque from 186 to 195 in–lb (21 to 22 N–m).
52.Place O–ring, solenoid coil, O–ring, washer, lock
washer and nut onto solenoid valve stem. Coil should be
installed so the "KANZAKI" molded into the coil has the
"I" nearest the nut location. Torque nut from 52 to 69 in–
lb (5.9 to 7.8 N–m).
Groundsmaster 7200/7210
7
3
1. Sleeve
2. Spool
3. Pin
4. Sleeve holes
Page 4 – 77
6
5
2
1
Figure 93
5. Spool step
6. Solenoid valve stem
7. Solenoid coil
Hydraulic System
4