Connect To A Network For Out-Of-Band Management; Connect The Pic Cables - Juniper M320 Quick Start Manual

M320 Multiservice Edge Router Quick Start

Connect to a Network for Out-of-Band Management

Connect the PIC Cables

20
Plug the other end into the management device.
4.
Tighten the screws on the connector.
5.
NOTE: Before you can use the Ethernet management port to connect to a
network for out-of-band management, you must perform the initial Junos
OS configuration after the router has been powered on. See
Initial Software Configuration" on page 26
Locate the appropriate cable and connector.
1.
Plug one of the Ethernet cable connectors into the Ethernet management port labeled
2.
ETHERNET on the CIP.
Plug the other end into the networking device.
3.
WARNING: Do not look directly into fiber-optic transceivers or into the ends
of fiber-optic cables. Fiber-optic transceivers contain laser light sources that
can damage your eyes.
CAUTION: To prevent damage to fiber-optic components and fiber-optic
cables, observe the following precautions:
Do not leave a fiber-optic transceiver uncovered except when inserting or
removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
Do not bend fiber-optic cable beyond its maximum bend radius. An arc
smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
Do not let the fiber-optic cable hang from the connector. Do not allow
fastened loops of cable to dangle, which stresses the cable at the fastening
point.
Identify the appropriate cable to be connected to each PIC.
1.
Insert the appropriate cable connector into the PIC cable receptacle.
2.
Drape the cable over the bobbins of the cable management system to protect them
3.
from bending past their recommended bend radius.
Insert the appropriate cable connector into the cable connector port on the FIC or PIC
4.
faceplate.
"Step 8: Perform
Copyright © 2016, Juniper Networks, Inc.