Step 8: Perform Initial Software Configuration; Entering Configuration Mode; Configuring User Accounts And Passwords - Juniper M320 Quick Start Manual

M320 Multiservice Edge Router Quick Start

Step 8: Perform Initial Software Configuration

Entering Configuration Mode

Configuring User Accounts and Passwords

26
The M320 Multiservice Edge Router is shipped with the Junos OS preinstalled and ready
to be configured when the M320 router is powered on. These procedures connect a router
to the network but do not enable it to forward traffic. For complete information about
enabling the router to forward traffic, including examples, see the Junos OS configuration
guides.
NOTE: These procedures enable you to use the management Ethernet port
labeled
ETHERNET
configuration, use a device attached to the
For more information about the commands in this procedure see the Junos OS
Administration Library for Routing Devices
1. Entering Configuration Mode on page 26
Configuring User Accounts and Passwords on page 26
2.
Configuring System Attributes on page 27
3.
Committing the Configuration on page 28
4.
Verify that the network device is powered on.
1.
Log in as the root user. There is no password.
2.
Amnesiac <ttyd0>
login: root
Start the CLI.
3.
root@% cli
root>
Enter configuration mode.
4.
root> configure
Entering configuration mode.
[edit]
root#
For information about using an encrypted password or an SSH public key string (DSA or
RSA), see authentication.
Add a password to the root administration user account. Enter a clear-text password.
1.
[edit]
root# set system root-authentication plain-text-password
New password: password
Retype new password: password
on the connector interface panel (CIP). For the initial
CONSOLE
Copyright © 2016, Juniper Networks, Inc.
port on the CIP.