Remove Components - Juniper M320 Quick Start Manual

M320 Multiservice Edge Router Quick Start
14

Remove Components

NOTE: For complete instructions on removing router components, see the
procedures for installing the router without a mechanical lift in the M320
Multiservice Edge Router Hardware Guide.
Before lifting the router, you must remove the following components (see
Figure 5 on page 15:
Power supplies
Cable management system
Switch Interface Boards (SIBs)
Control Boards (CBs)
Fan trays
Flexible PIC Concentrators (FPCs)
To remove the components from the router, perform the following procedure:
Slide each component out of the chassis evenly so that it does not become stuck or
1.
damaged.
Label each component as you remove it so you can reinstall it in the correct location.
2.
Immediately store each removed component in an electrostatic bag.
3.
Do not stack removed components. Lay each one on a flat surface.
4.
Copyright © 2016, Juniper Networks, Inc.