Juniper M320 Quick Start Manual page 16

Multiservice edge router

Hide thumbs Also See for M320:

Table of Contents

M320 Multiservice Edge Router Quick Start

WARNING:

Do not lift the router using the installation handle or the handles

on top of the chassis. Use these handles only to help position the router.

Make sure the rack is in its permanent location and is secured to the building.

Move the router as close as possible to the rack. Use a pallet jack if one is available.

With one person on each side and one person in the front, hold the bottom of the

chassis and carefully lift it onto the large and small (if installed) mounting shelves.

With one person pulling on the installation handle from the rear of the rack or cabinet

while another person pushes on the front-mounting flanges, slide the router onto the

mounting shelves until the mounting brackets or front-mounting flanges contact the

rack rails or spacer bars (depending on your type of installation).

Install the mounting screws:

Four-post rack or cabinet: Install a mounting screw and a cage nut into each of the

holes aligned with the threaded holes in the spacer bars.

Open-frame rack: Install a mounting screw into each of the open mounting holes

aligned with the rack, starting from the bottom.

Figure 6: Lift the Router into the Rack

Table of Contents