Connect To A Network For Out-Of-Band Management; Connect The Pic Cables - Juniper T320 Quick Start Manual

Connect to a Network for Out-of-Band Management

Connect the PIC Cables

Copyright © 2015, Juniper Networks, Inc.
Plug the other end of the cable into the management device.
4.
Tighten the screws on the connectors.
5.
NOTE: Before you can use the Ethernet management port to connect to a
network for out-of-band management, you must perform the initial Junos
OS configuration after the router has been powered on. See
Initial Software Configuration" on page
Locate the appropriate cable and connector.
1.
Plug one of the Ethernet cable connectors into the
2.
Plug the other end into the networking device.
3.
WARNING: Do not look directly into the ends of fiber-optic cables or into the
transceivers on the interface faceplate. Fiber-optic transceivers emit laser
light that can damage your eyes.
CAUTION: To prevent damage to fiber-optic transceivers and fiber-optic
cables, observe the following precautions:
Do not leave a fiber-optic transceiver uncovered except when inserting or
removing cable. The safety plug keeps the port clean and prevents
accidental exposure to laser light.
Do not bend fiber-optic cable beyond its maximum bend radius. An arc
smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
Do not let fiber-optic cable hang free from the connector. Do not allow
fastened loops of cable to dangle, which stresses the cable at the fastening
point.
Identify the appropriate cable to be connected to each PIC. Remove any rubber safety
1.
plugs from the cable receptacles, and insert the appropriate cable connector into the
PIC cable receptacle.
Drape the cable over the bobbins of the cable management system to protect them
2.
from bending past their recommended bend radius.
Connect to a Network for Out-of-Band Management
22.
port on the CIP.
ETHERNET
"Step 7: Perform
19