Igmp - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

IGMP

This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Advanced / IGMP page, you can allow the access point to use IGMP.
IGMP is used for managing multicast traffic (transferring data to a group of destinations). This
protocol allows using network resources for some applications, e.g., for streaming video, more
efficiently.
The following elements are available on the page:
Parameter
Enable
IGMP version
Interface
After specifying the needed parameters, click the APPLY button.
Figure 136. The Advanced / IGMP page.
Move the switch to the right to enable IGMP.
Select a version of IGMP from the drop-down list.
From the drop-down list, select a connection of the Dynamic IPv4 or
Static IPv4 type for which you need to allow multicast traffic (e.g.
streaming video).
Page 178 of 235
Configuring via Web-based Interface
Description