D-Link DAP-600P User Manual page 82

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Parameter
Option 82 Circuit ID
Option 82 Remote ID
Option 82 Subscriber ID
When all needed settings are configured, click the APPLY button.
In the DHCP Options section, you can change default values for some options of DHCP protocol
(IP address, subnet mask, DNS servers) or specify additional parameters which the built-in DHCP
server should send to clients to configure the local network.
Figure 66. Configuring the local interface. The IPv4 tab. The section for configuring DHCP options.
To do this, click the ADD button (
Figure 67. Configuring the local interface. The IPv4 tab. The window for configuring a DHCP option.
In the opened window, you can specify the following parameters:
Parameter
Known DHCP options
Options value
Force
After specifying the needed parameters, click the APPLY button.
Available if the Router or WISP Repeater mode was selected in
the Initial Configuration Wizard.
The value of the relevant field of DHCP option 82. Do not fill in the
fields unless your ISP or the administrator of the external DHCP
server provided these values.
).
From the drop-down list, select an option which you want to
configure.
Specify the value for the selected option.
Move the switch to the right to let the DHCP server send the
selected option regardless of the client's request.
Move the switch to the left to let the DHCP server send the selected
option only when the client requests it.
Page 82 of 235
Configuring via Web-based Interface
Description
Description