Ipv6 - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

IPv6

Go to the IPv6 tab to change or add the IPv6 address of the access point, configure IPv6 addresses
assignment settings, specify MAC address and IPv6 address pairs, or add own DNS records.
Figure 70. Configuring the local interface. The IPv6 tab. The Local IPv6 Address section.
To add an IPv6 address of the access point, click the ADD button (
address of the access point, select it in the table.
Figure 71. Configuring the local interface. The IPv6 tab. The window for adding an IPv6 address.
In the opened window, you can specify the following parameters:
IPv6 address
Prefix
Gateway IPv6 address
Click the APPLY button.
To remove the IPv6 address, select it in the table and click the DELETE button in the opened
window. Then click the APPLY button.
Local IPv6 Address
The IPv6 address of the access point in the local subnet. By default,
the following value is specified: fd00::1.
The length of the prefix subnet. By default, the value 64 is
specified.
Available if the Access point or Repeater mode was selected in
the Initial Configuration Wizard.
The gateway IPv6 address which is used by the access point to
connect to the Internet (e.g., for synchronizing the system time with
an NTP server). Optional.
Page 85 of 235
Configuring via Web-based Interface
). To change the IPv6