Dns - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

DNS

On the Advanced / DNS page, you can add
DNS servers are used to determine the IP address from the name of a server in Intranets or the
Internet (as a rule, they are specified by an ISP or assigned by a network administrator).
You can specify the addresses of DNS servers manually on this page or configure the access point
to obtain DNS servers addresses automatically from your ISP upon installing a connection. Also
here you can specify addresses of reserve DNS servers which the access point can use if the
addresses specified manually or obtained automatically are unavailable.
!
When you use the built-in DHCP server, the network parameters (including DNS servers)
are distributed to clients automatically.
7 Correct operation of the page displayed if the Access point or Repeater mode was selected in the Initial
Configuration Wizard will be implemented in the next firmware version.
7
DNS servers to the system.
Figure 116. The Advanced / DNS page.
Page 152 of 235
Configuring via Web-based Interface