D-Link DAP-600P User Manual page 36

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
9. In the opened window, in the list of available wireless networks, select the wireless network
DAP-600P (for operating in the 2.4GHz band) or DAP-600P-5G (for operating in the
5GHz band) and click the Connect button.
10. In the opened window, enter the network key (see WPS PIN on the barcode label on the
bottom panel of the device) in the Security key field and click the OK button.
11. Wait for about 20-30 seconds. After the connection is established, the network icon will be
displayed as the signal level scale.
Now you can connect to the web-based interface of DAP-600P for configuring all needed
parameters. To gain access to an external network (to the Internet), you also need to specify the
default gateway and the addresses of DNS servers.
If you perform initial configuration of the access point via Wi-Fi connection, note that
!
immediately after changing the wireless default settings of the access point you will need
to reconfigure the wireless connection using the newly specified settings.
Figure 19. The list of available networks.
Page 36 of 235
Installation and Connection