D-Link DAP-600P User Manual page 187

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Parameter
IPsec-SA lifetime
If you need to specify IP addresses of local and remote subnets for this tunnel, click the ADD button
( ) in the Tunneled Networks section.
If the IPsec tunnel operates over IKEv1 (1 is selected from the IKE version list in the The First
Phase section), you can create only one subnet.
If the IPsec tunnel operates over IKEv2 (2 is selected from the IKE version list in the The First
Phase section), you can create several subnets.
Figure 141. The page for adding an IPsec tunnel. The window for adding a tunneled network.
In the opened window, you can specify the following parameters:
Parameter
Local network
Remote subnet
MTU
To edit fields in the Tunneled Networks section, select the relevant line in the table. In the
opened window, change the needed parameters and click the SAVE button.
To remove a subnet, select the checkbox located to the left of the relevant line in the table and click
the DELETE button (
After configuring all needed settings for the IPsec tunnel, click the APPLY button.
The lifetime of Phase 2 keys in seconds. After the specified period it is
required to renegotiate the keys. The value specified in this field
should be greater than zero.
A local subnet IP address and mask.
A remote subnet IP address and mask.
The maximum size (in bytes) of a non-fragmented packet. The field is
displayed when the Manual value is selected from the TCP MSS
drop-down list in the General Settings section.
). Also you can remove a subnet in the editing window.
Page 187 of 235
Configuring via Web-based Interface
Description
Description