D-Link DAP-600P User Manual page 188

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
To edit the parameters of an existing tunnel, in the Tunnels section, select the relevant tunnel in the
table. On the opened page, change the needed parameters and click the APPLY button.
To disconnect an existing tunnel and establish it again, select the checkbox located to the left of the
relevant line in the table and click the RECONNECT button.
To remove an existing tunnel, select the checkbox located to the left of the relevant line in the table
and click the DELETE button (
To disable VPN tunnels based on IPsec protocol, move the Enable switch to the left.
). Also you can remove a tunnel on the editing page.
Page 188 of 235
Configuring via Web-based Interface