D-Link DAP-600P User Manual page 158

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
In the opened window, you can specify the following parameters:
Parameter
Enable rule
Action
MAC address
After specifying the needed parameters, click the SAVE button.
To edit a rule, select the relevant line in the table. In the opened window, change the needed
parameters and click the SAVE button.
To remove a rule, select the checkbox located to the left of the relevant line of the table and click
the DELETE button (
To set a schedule 8 for the MAC filter rule, click the Add Schedule button (
corresponding to this rule. In the opened window, you can create a new schedule (see the Schedule
section, page 207) or use the existing one. Existing schedules are displayed in the Interval of
execution drop-down list in the simplified mode.
To enable the MAC filter rule at the time specified in the schedule and disable it at the other time,
select the Enable value from the Action for rule upon activation of schedule drop-down list
and click the SAVE button.
To disable the MAC filter rule at the time specified in the schedule and enable it at the other time,
select the Disable value from the Action for rule upon activation of schedule drop-down
list and click the SAVE button.
To change or delete the schedule for a rule, click the Select schedule button (
corresponding to this rule. In the opened window, change the parameters and click the SAVE button
or click the DELETE FROM SCHEDULE button.
8 Schedule settings are available on the Firewall / MAC filter page if the Router or WISP Repeater mode was
selected in the Initial Configuration Wizard.
Move the switch to the right to enable the rule.
Move the switch to the left to disable the rule.
Select an action for the rule.
•
Deny: Blocks access to the Internet for the device with the
specified MAC address even if the default mode allows
access for all devices.
• Allow: Allows access to the access point's network and to
the Internet for the device with the specified MAC address
even if the default mode denies access for all devices.
The MAC address of a device from the access point's LAN. You can
enter the MAC address of a device connected to the access point's
LAN at the moment. To do this, select the relevant device from the
drop-down list (the field will be filled in automatically).
). Also you can remove a rule in the editing window.
Page 158 of 235
Configuring via Web-based Interface
Description
) in the line
) in the line