Upnp Igd - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

UPnP IGD

This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Advanced / UPnP IGD page, you can enable the UPnP IGD protocol. The access point
uses the UPnP IGD protocol for automatic configuration of its parameters for network applications
requiring an incoming connection to the access point.
If you want to manually specify all parameters needed for network applications, move the Enable
switch to the left. Then go to the Firewall / Virtual Servers page and specify needed settings.
If you want to enable the UPnP IGD protocol in the access point, move the Enable switch to the
right.
When the protocol is enabled, the following parameters of the access point are displayed on the
page:
Parameter
Protocol
IP address
Private port
Public port
Description
Duration
Figure 133. The Advanced / UPnP IGD page.
A protocol for network packet transmission.
The IP address of a client from the local area network.
A port of a client's IP address to which traffic is directed from a
public port of the access point.
A public port of the access point from which traffic is directed to a
client's IP address.
Information transmitted by a client's network application.
The time period during which the UPnP IGD protocol has been used.
Page 175 of 235
Configuring via Web-based Interface
Description