D-Link DAP-600P User Manual page 219

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
4. Click the APPLY button. The System date and System time fields will be filled in
automatically.
In some cases NTP servers addresses are provided by your ISP. In this case, you need to move the
Get NTP server addresses using DHCP switch to the right and click the APPLY button.
Contact your ISP to clarify if this setting needs to be enabled. If the Get NTP server addresses
using DHCP switch is moved to the right, the NTP Servers section is not displayed.
To allow connected devices to use the IP address of the access point in the local subnet as a time
server, move the Run as a server for the local network switch to the right and click the
APPLY button.
When the access point is powered off or rebooted, the system time is reset to the default
!
value. If you have set automatic synchronization for the system time, the internal clock of
the device will be configured after connecting to the Internet. If you have set the system
time manually, you need to set the time and date again (see above).
Page 219 of 235
Configuring via Web-based Interface