Why Can't I Configure My P-660Hwp-Dx Using Web Configurator/Telnet Over Wan - ZyXEL Communications P-660HWP-Dx Support Notes

3. Why can't I configure my P-660HWP-Dx using Web Configurator/Telnet
over WAN?
There are four reasons that WWW/Telnet from WAN is blocked.
(1) When the firewall is turned on, all connections from WAN to LAN are
blocked by the default ACL rule. To enable Telnet from WAN, you must turn
the firewall off, or create a firewall rule to allow WWW/Telnet connection
from WAN. The WAN-to-LAN ACL summary will look like as shown below.
WWW (For accessing Web Configurator):
Source IP= Remote trusted host
Destination IP= router' WAN IP
Service= TCP/80
Action=Forward
TELNET (For accessing Command Line Interface):
Source IP= Telnet Client host
Destination IP= router' WAN IP
Service= TCP/23
Action=Forward
(2)You have disabled WWW/Telnet service in Web Configurator, Advanced
setup, Advanced -> Remote MGNT:
(3) WWW/Telnet service is enabled but your host IP is not the secured host
entered in Web Configurator, Advanced setup, Advanced -> Remote
MGNT:
All contents copyright © 2007 ZyXEL Communications Corporation.
P-660HWP-Dx Support Notes
29