Figure 167 Applying Schedule Set(S) To A Remote Node (Pppoe) - ZyXEL Communications ADSL2+ Ethernet/USB Gateway 660RU-Tx Series User Manual

Table 73 Menu 26.1 Schedule Set Setup (continued)
FIELD
Action
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:
Once your schedule sets are configured, you must then apply them to the desired remote
node(s). Enter 11 from the Main Menu and then enter the target remote node index. Using
[SPACE BAR], select PPPoE or PPPoA in the Encapsulation field and then press
[ENTER] to make the schedule sets field available as shown next.

Figure 167 Applying Schedule Set(s) to a Remote Node (PPPoE)

Rem Node Name= MyISP
Active= Yes
Encapsulation= PPPoA
Multiplexing= LLC-based
Service Name= N/A
Incoming:
Rem Login=
Rem Password= ********
Outgoing:
My Login= ChangeMe
My Password= ********
Authen= CHAP/PAP
You can apply up to four schedule sets, separated by commas, for one remote node. Change
the schedule set numbers to your preference(s).
Chapter 29 Call Scheduling
DESCRIPTION
Forced On means that the connection is maintained whether or not there is a demand
call on the line and will persist for the time period specified in the Duration field.
Forced Down means that the connection is blocked whether or not there is a demand
call on the line.
Enable Dial-On-Demand means that this schedule permits a demand call on the line.
Disable Dial-On-Demand means that this schedule prevents a demand call on the line.
" to save your configuration, or press [ESC] at any time to cancel.
Menu 11.1 - Remote Node Profile
Press ENTER to Confirm or ESC to Cancel:
Prestige 660RU-Tx Series User's Guide
Press ENTER to Confirm
Route= IP
Bridge= No
Edit IP/Bridge= No
Edit ATM Options= No
Edit Advance Options= N/A
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Schedules Sets= 1,2,3,4
Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 0
240