Table of Contents
Advertisement
Prestige 660RU-Tx Series User's Guide
Figure 85 Menu 11.1 Remote Node Profile
Rem Node Name= MyISP
Active= Yes
Encapsulation= PPPoE
Multiplexing= LLC-based
Service Name=
Incoming:
Rem Login=
Rem Password= ********
Outgoing:
My Login= ?
My Password= ?
Authen= CHAP/PAP
Press ENTER to Confirm or ESC to Cancel:
Move the cursor to the Edit Advance Options field, press [SPACE BAR] to select Yes, then
press [ENTER] to display Menu 11.8 – Advance Setup Options.
Figure 86 Menu 11.8 Advance Setup Options
The following table describes the fields in this menu.
Table 45 Menu 11.8 Advance Setup Options
FIELD
PPPoE pass-through
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:
153
Menu 11.1 - Remote Node Profile
Menu 11.8 - Advance Setup Options
PPPoE pass-through= No
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Press [SPACE BAR] to select Yes and press [ENTER] to enable PPPoE pass
through. In addition to the Prestige's built-in PPPoE client, you can enable
PPPoE pass through to allow up to ten hosts on the LAN to use PPPoE client
software on their computers to connect to the ISP via the Prestige. Each host
can have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for applications where NAT is not
appropriate.
Press [SPACE BAR] to select No and press [ENTER] to disable PPPoE pass
through if you do not need to allow hosts on the LAN to use PPPoE client
software on their computers to connect to the ISP.
" to save your configuration, or press [ESC] at any time to cancel.
Route= IP
Bridge= No
Edit IP/Bridge= No
Edit ATM Options= No
Edit Advance Options= Yes
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Schedule Sets=
Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 0
Press ENTER to Confirm
Chapter 18 Remote Node Configuration
Advertisement
Table of Contents
Troubleshooting
