ZyXEL Communications ADSL2+ Ethernet/USB Gateway 660RU-Tx Series User Manual page 63

Table 11 LAN Setup (continued)
LABEL
Client IP Pool
Starting Address
Size of Client IP
Pool
Primary DNS Server Enter the IP addresses of the DNS servers. The DNS servers are passed to the
Secondary DNS
Server
Remote DHCP
Server
TCP/IP
IP Address
IP Subnet Mask
RIP Direction
RIP Version
Multicast
Any IP Setup
Apply
Cancel
Chapter 5 LAN Setup
DESCRIPTION
This field specifies the first of the contiguous addresses in the IP address pool.
This field specifies the size or count of the IP address pool.
DHCP clients along with the IP address and the subnet mask.
As above.
If Relay is selected in the DHCP field above then enter the IP address of the
actual remote DHCP server here.
Enter the IP address of your Prestige in dotted decimal notation, for example,
192.168.1.1 (factory default).
Type the subnet mask assigned to you by your ISP (if given).
Select the RIP direction from None, Both, In Only and Out Only.
Select the RIP version from RIP-1, RIP-2B and RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a multicast group. The Prestige supports both IGMP
version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.
Select the Active checkbox to enable the Any IP feature. This allows a computer
to access the Internet without changing the network settings (such as IP address
and subnet mask) of the computer, even when the IP addresses of the computer
and the Prestige are not in the same subnet.
When you disable the Any IP feature, only computers with dynamic IP addresses
or static IP addresses in the same subnet as the Prestige's LAN IP address can
connect to the Prestige or access the Internet through the Prestige.
Click Apply to save your changes back to the Prestige.
Click Cancel to begin configuring this screen afresh.
Prestige 660RU-Tx Series User's Guide
62