3911GNITION SYSTEM
Alternator - checkinl( the stator windinl(
Condition
The alternator is disconnected.
Stator winding- checking the resistance
Measure the resistance between the specified points.
Q
Alternator, connector
CR
pin
1
(Yellow) - Alternator, connector
CR
pin
1
(Yellow)
Alternator
Stator winding resistance at: 20'C 11.53 ... 2.07
n
(68
'F)
•
II the displayed value does not equal the setpoint value:
-
Replace the stator.
Stator winding- check the signal wire lor a short circuit to ground <terminal31l
Measure the resistance between the specified points.
Q
Alternator, connector
CR
pin
1
(Yellow) - Measuring point
Ground (-)
I
Resistance
loon
•
If the displayed value does not equal the setpoint value:
-
Replace the stator.
Ramovinl( ilia stator
301237-10
Installinl( the stator
301237-11
Condition
The alternator cover has been removed.
-
Remove screw
and the retaining bracket.
-
Remove cable support sleeve
from the alternator case.
-
Remove screws
-
Take the stator out of the alternator cover.
-
Position the stator in the alternator cover.
-
Mou nt screws
Guideline
Screw, stator bracket
M5
6 Nm
(4.4 Ibf
ftl
-
Position cable support sleeve
in the alternator case.
-
Position the retaining bracket. Mount and tighten screw
Guideline
Screw, stator cable holder
M5
6 Nm
(4.4
Ibl
ftl
Loctit'" 243
111
202