Removing The Rear Brake Disc; Installing The Rear Brake Disc - KTM 450 SX-F EU Repair Manual

1 O/REAR WHEEL
88
RemDYinl til.
I8lIr
brak. disc
- Position chain adjuster . Mount nut but do not tighten it yet.
- Make sure that chain adjusters are fitted correctly on adjusting screws
- Check the chain tension. (eo p. 89)
- Tighten nut
Guideline
I
Nut, rear wheel spindle
I
M20x1.5
180
Nm (59 Ibf ft)
• Info
I
The wide adjustment range of the chain adjusters (32 mm (1.26 in))
enables different secondary ratios with the same chain length.
Chain adjusters can be turned by 180·.
- Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
Subsequent work
- Remove the motorcycle from the lift stand.
(eo
p. 9)
Preliminary work
- Raise the motorcycle with the lift stand. (eo p.
9)
- Remove the rear wheel. (eo p.
87)
Main work
- Remove screws . Take off the brake disc.
Main work
- Clean the contact surface of the brake disc.
- Position the brake disc with the label facing outward. Mount and tighten screws
Guideline
Screw, rear brake disc M6
Subsequent work
- Install the rear wheel. (eo p. 87)
14
Nm
(10.3 Ibf
It)
- Remove the motorcycle from the lift stand.
(eo
p. 9)
Loctit'" 243 111