Installing The Carburetor - KTM 450 SX-F EU Repair Manual

31/CARBURETOR
177
- Remove the carburetor.
Main work
- Position the carburetor.
- Mount the hot start activation
- Mount the rubber sleeve on the cylinder head.
- Insert the carburetor into the rubber sleeve.
• Info
I
Align stud on the carburetor with notch in the rubber sleeve. The car-
buretor must be positioned vertically.
- Position and tighten hose clip
- Position the carburetor vent hoses.
- Attach the connector of throttle position sensor
- Mount cable binder
- Position and tighten hose clip
- Connect the cables.
- Check the throttle cable routing. (.- p. 46)
- Move the handlebar to the straight-ahead position.
- Turn adjusting screw in as far as possible.
- Turn adjusting screw so that there is play in the throttle cable at the throttle
grip.
Guideline
1
Play in throttle cable
13 ...
5
mm
(0.12 ... 0.2
in)
- Tighten nut
- Press and hold the throttle grip in the closed setting. Turn adjusting screw out
until there is no play in throttle cable
- Tighten nut