Installing The Locking Lever; Installing The Shift Drum Locating Uni; Installing The Shift Shaft; Installing The Suction Pumps - KTM 450 SX-F EU Repair Manual

301ENGINE ASSEMBLY
161
Installinl til. suction
lIum~
- Mount locking lever with the sleeve and spring.
- Mount and tighten screw with the washer.
Guideline
Screw, locking lever M5 6Nm
Lactilee 243111
(4.4 Ibf
tt)
- Push away locking lever from the shift drum locating unit and position the shift
drum locating unit
• Info
I
The flat areas of the shift drum locating unit are not symmetric.
- Relieve tension from the locking lever.
- Mount and tighten screw .
Guideline
Screw, shift drum locating M6 10 Nm
(7.4lbfft)
- Slide shift shaft with the washer into the bearing seat.
Lactile"' 243111
- Push sliding plate away from the shift drum locating unit. Insert the shift shaft
all the way.
- Let sliding plate engage in the shift drum locating unit.
- Shift through the transmission.
- Lubricate the oil pump shaft, internal rotor, and external rotor before assembly.
I
Engine oil (SAE lOW/50) ( .. p. 224)
- Mount suction pump with the pin and oil pump shaft
• Info
I
The rounded side of the suction pump faces the engine case.
- Position the oil pump cover. Mount and tighten screws
Guideline
Screw, oil pump cover
, / Marking faces upward.
- Insert pin
M5 6Nm
(4.4 Ibf ft)
Lactilee 243111