Adding A Qos Queue - ZyXEL Communications ZyXEL Prestige P-870HW-51a v2 User Manual

Chapter 11 Quality of Service (QoS)
Table 38 QoS Queue Setup
LABEL
Modify
Apply

11.4.1 Adding a QoS Queue

Click the Add button or the edit icon in the Queue Setup screen to configure a
queue.
Figure 65 QoS Queue Setup: Add
The following table describes the labels in this screen.
Table 39 QoS Queue Setup: Add
LABEL
Active
Queue Name
Queue
Interface
Queue
Precedence
Back
Apply
Cancel
132
DESCRIPTION
Click the edit icon to go to the screen where you can edit the queue.
Click the remove icon to delete an existing queue. Note that subsequent
rules move up by one when you take this action.
Click Apply to save your changes back to the ZyXEL Device.
DESCRIPTION
Select to enable or disable this rule.
Enter the descriptive name of this rule.
Select the interface to which this rule is applied.
Select the priority queue of this rule.
The smaller the number, the higher the priority level.
Click Back to return to the previous screen without saving.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
P-870HW-51a v2 User's Guide