ZyXEL Communications ZyXEL Prestige P-870HW-51a v2 User Manual page 61

Table 12 WAN > More Connections: Edit (continued)
LABEL
Symmetric
Fullcone
VLAN
VLAN Active
VLAN ID
Priority
Back
Apply
Reset
Advanced Setup
P-870HW-51a v2 User's Guide
DESCRIPTION
Select this option to enable symmetric NAT on this connection.
This field is available only when you select Active NAT.
Select this option to enable full cone NAT on this connection.
This field is available only when you select Active NAT.
This section is available in this screen only when you select Bridge in
the Mode field.
Select this option to enable VLAN multiplexing of multiple protocols
over a single virtual circuit. You need to assign a VLAN ID and priority
level to traffic through each WAN connection. All WAN connections
share one MAC address. This allows the backbone switch to classify
and service traffic based on the VLAN tag, instead of the MAC address.
Otherwise, disable VLAN multiplexing and each WAN connection has
its own MAC address.
Note: This field is only configurable for the first WAN connection.
When you change the setting here, all existing WAN
connections will be removed except for the first WAN
connection.
Enter a VLAN ID number for traffic that goes through this connection.
Enter a priority level for traffic that goes through this connection.
Click this to return to the More Connections screen with saving your
changes.
Click this to save the changes.
Click this to begin configuring this screen afresh.
Click this button to display the More Connections Advanced Setup
screen and edit more details of your WAN setup.
This button is not available when you select Bridge in the Mode field.
Chapter 5 WAN Setup
61