ZyXEL Communications ZyXEL Prestige P-870HW-51a v2 User Manual page 55

Table 9 WAN > Internet Connection (continued)
LABEL
Symmetric
Fullcone
DNS Servers
First DNS Server
Second DNS
Server
VLAN
VLAN Active
VLAN ID
Priority
Apply
Reset
Advanced Setup
P-870HW-51a v2 User's Guide
DESCRIPTION
Select this option to enable symmetric NAT on this connection.
This field is available only when you select Active NAT.
Select this option to enable full cone NAT on this connection.
This field is available only when you select Active NAT.
Select From ISP if your ISP dynamically assigns DNS server
information (and the ZyXEL Device's WAN IP address).
Select Static IP if you have the IP address of a DNS server.
If you select Static IP, enter the DNS server's IP address in the field
to the right.
This section is available in this screen only when you select Bridge in
the Mode field.
Select this option to enable VLAN multiplexing of multiple protocols
over a single virtual circuit. You need to assign a VLAN ID and priority
level to traffic through each WAN connection. All WAN connections
share one MAC address. This allows the backbone switch to classify
and service traffic based on the VLAN tag, instead of the MAC address.
Otherwise, disable VLAN multiplexing and each WAN connection has
its own MAC address.
Note: This field is only configurable for the first WAN connection.
When you change the setting here, all existing WAN
connections will be removed except for the first WAN
connection.
Enter a VLAN ID number for traffic that goes through this connection.
Enter a priority level for traffic that goes through this connection.
Click this to save the changes.
Click this to begin configuring this screen afresh.
Click this button to display the Advanced WAN Setup screen and
edit more details of your WAN setup.
This button is not available when you select Bridge in the Mode field.
Chapter 5 WAN Setup
55